|
|
GEO help: Mouse over screen elements for information. |
|
Status |
Public on Jan 20, 2019 |
Title |
160831_NAT_H3K27Ac (MGH_4_NAT) |
Sample type |
SRA |
|
|
Source name |
matched normal adjacent to MGH_4 chordoma
|
Organism |
Homo sapiens |
Characteristics |
cell type: matched normal adjacent to MGH_4 chordoma antibody: H3K27ac barcode: TTGGAGGT antibody maker: abcam antibody catalog number: ab4729
|
Extracted molecule |
genomic DNA |
Extraction protocol |
For H3K27ac ChIP of patient-derived tissue: approximately 100 mg of flash-frozen tissue was minced into 1-2 mm pieces and incubated in 1% formaldehyde for 15 minutes, followed by quenching with glycine (125 mM final concentration). Fixed tissue pieces were homogenized with a Tissue Tearor rotor stator homogenizer (Biospec) set to 30,000 RPM for 60 seconds. Homogenate was washed with ice-cold PBS containing 1X HALT protease inhibitor. Homogenized pellets were then resuspended in cytosolic lysis buffer (50 mM HEPES pH 7.5, 140 mM NaCl, 1 mM EDTA, 10% glycerol, 0.5% IGEPAL, 0.25% Triton X-100, 1X HALT protease inhibitor) and the protocol was continued as described below. For H3K27ac ChIP of chordoma cell lines: Chordoma cell lines were grown in 175 cm collagen I-coated plates (3 plates per cell line) and cross-linked by adding 1/10 of the cell culture volume of 11% formaldehyde solution (1M HEPES-KOH pH 7.5, 0.5 M EDTA pH 8.0, 0.5 M EGTA pH 8.0, 5 M NaCl, 37% formaldehyde) for 10 minutes, followed by quenching (125 mM glycine). Cells were washed in PBS and harvested by cell scraper in PBS. Cells were centrifuged at 1,350 X g for 5 min at 4°C, washed with PBS, and centrifuged again at 1,350 X g for 5 min at 4°C. Cell pellets were flash frozen and stored at -80°C until further processing. For both cell line and tissue ChIP-seq: samples were subsequently rotated end-over-end for 10 minutes at 4º C in cytosolic lysis buffer and then collected by spinning at 1,350 x g for 5 minutes. Samples were resuspended in nuclear lysis buffer (10 mM Tris-HCl pH 8, 200 mM NaCl, 1 mM EDTA, 0.5mM EGTA, 1X HALT protease inhibitor) and rotated end-over-end for 10 minutes at 4º C and spun at 1,350 x g for 5 minutes. Samples were resuspended in 1 mL sonication buffer ( 0.1% Na-Deoxycholate, 50 mM HEPES pH 7.5, 140 mM NaCl, 1 mM EDTA, 1 mM EGTA, 1% Triton X-100, 1X HALT protease inhibitor) with SDS added to a final concentration of 0.5%. Chromatin was sheared by sonication using a Bioruptor water bath sonicator (Diagenode) for 25 cycles. Samples were clarified by centrifuging 10 minutes at 20,000 x g at 4º C. A 50 uL aliquot of supernatant was set aside as non-IP input control. The remaining sheared chromatin was diluted 1:5 in sonication buffer and each sample was incubated overnight at 4º C with 100 uL of Protein G Dynabeads (Life Technologies) bound with 10 µg of anti-H3K27ac antibody (abcam, #ab4729). Beads were washed while rotating end-over-end at 4º C with the following buffers: twice in sonication buffer, once in sonication buffer with NaCl added to a final concentration of 500 mM, once in LiCl wash buffer (20 mM Tris pH 8, 1 mM EDTA, 250 mM LiCl, 0.5% IGEPAL, 0.5% Na-Deoxycholate), and once in TE-NaCl buffer (50 mM Tris-HCl pH 8, 50 mM NaCl). Chromatin was eluted by resuspending beads in 200 uL elution buffer (50 mM Tris-HCl pH 8, 10 mM EDTA, 1% SDS) and heating for 15 minutes at 65º C. Beads were pelleted by centrifuging at 20,000 G for 30 seconds and supernatant was collected. Elution buffer (150 uL) was also added to input chromatin samples. Samples were incubated at 65º C overnight to reverse crosslinks. Samples were then incubated with RNAse A (Thermo Scientific) for 2 hours at 37º C, followed by incubation with Proteinase K (Ambion) for 30 minutes at 55º C. DNA isolation was performed via phenol-chloroform extraction and concentrated by ethanol precipitation. Sequencing libraries were generated with the Thruplex DNAseq Single Index Kit (Rubicon) and sequenced on an Illumina NextSeq 500 with single-end, 75 bp reads. ChIP-seq was performed once for each sample.
|
|
|
Library strategy |
ChIP-Seq |
Library source |
genomic |
Library selection |
ChIP |
Instrument model |
Illumina NextSeq 500 |
|
|
Data processing |
All datasets were aligned using Bowtie2 (version 2.2.1) to build version NCBI37/HG19 (Langmead et al., 2009). Alignments were performed using all default parameters except for –N 1.
wiggles were made using MACS 1.4.2 pileups
Genome_build: hg19
Supplementary_files_format_and_content: .wig wiggles of read pileups across the whole genome
|
|
|
Submission date |
Jan 29, 2018 |
Last update date |
Jan 20, 2019 |
Contact name |
James Bradner |
E-mail(s) |
bradner_computation@dfci.harvard.edu
|
Organization name |
Dana-Farber Cancer Institute
|
Department |
Medical Oncology
|
Lab |
Bradner Lab
|
Street address |
450 Brookline
|
City |
Boston |
State/province |
MA |
ZIP/Postal code |
02215 |
Country |
USA |
|
|
Platform ID |
GPL18573 |
Series (2) |
GSE109791 |
Small-molecule targeting of brachyury transcription factor addiction in chordoma [ChIP-Seq] |
GSE109794 |
Small-molecule targeting of brachyury transcription factor addiction in chordoma |
|
Relations |
BioSample |
SAMN08428785 |
SRA |
SRX3623418 |
Supplementary file |
Size |
Download |
File type/resource |
GSM2967371_160831_NAT_H3K27Ac.wig.gz |
95.9 Mb |
(ftp)(http) |
WIG |
SRA Run Selector |
Raw data are available in SRA |
Processed data provided as supplementary file |
|
|
|
|
|